|
Due to the size and weight of the plate, we recommend two people install the receiver plate on the implement.
Items to be installed
|
 |
 |
 |
 |
|
Receiver Plate
RP6951
|
Right Angle Bracket
AG2813
|
Left Angle Bracket
AG2014
|
7/8"-14x3-Hex Bolt
AG2023
|
 |
 |
 |
 |
|
7/8"-14" Locknut
AG2024
|
Lynch Pin
AG2014
|
Top Link Pin
AG2013
|
Top Link Tube
AG2010
|
 |
 |
5/8”-11x2-Carriage Bolt
AG2803 |
5/8”-11 Hex Nut
AG2017 |
| Items already installed |
 |
 |
Strike Plate
AG2019 |
5/8x11x2 Nut
AG2802 |
To Install Plate to Implement
For shipping purposes, brackets are shipped upside down on the receiver plate.
1) Attach top link tube to top link arm of implement as shown in Figure 1. Several holes are made to allow for adjustment to your implement.
2) Attach the shorter end of the right bracket to the bottom holes of Receiver Plate using the 5/8” carriage bolts as shown in Figure 2. Bracket should be pointing down and with 3-hole side to implement.
3) Align hole of right bracket to hole of implement’s bottom arm and secure with 7/8-14 hex bolt and locknut as shown in Figure 2.
4) Repeat step four for the left bracket.
 |
 |
| FIGURE 1 |
FIGURE 2 |
All hardware is included for installation of your Receiver Plate. If you choose, you may use the existing hardware on your implement.
To Adjust Locking Pin to Strike Plate.
1) With Control Plate and Receiver Plate engaged, adjust strike plate to within 1/16” (or dime's width) or less of locking pin as shown in Figure 3.
As initial break-in could cause excessive clearance, check again after short time of use.
 |
| FIGURE 3 |
When Reciever Plate is installed, it should resemble photo below.
Should you encounter any problems with your Delta Hook™Rapid Hitch System™, please contact us immediately at 866-833-1160, M-F 8:30am—5:30pm e.s.t.
Printable (PDF) version of Receiver Plate Category 2
|
